Brother International DB2-B737 Network Users Manual - English - Page 13

6 Motor brake spacing 0 m m m mo m m mm mm mmom 0.2 mm 0.1 mm O 0.15 mm Window fro adjusting the brake spacing 0.3 mm *Adjust the brake spacing when about two years have passed. And also adjust when the brake generates abnormal noises and does not stop stably. Adjustment Procedures 1. It is recommended that you remove the motor pulley and measure the brake spacing in advance. The brake spacing is factory set at approx. 0.2 mm. 2. Remove the screw 0 and the pulley cover 0 3. Remove the V belt. 4. Remove the nut 0 and the motor pulley assembly 0. 5. Remove the washer 0 from the shaft 0 so that the brake spacing becomes 0.2 mm. The washer 0 is available with the thickness, 0.1 mm, 0.15 mm and 0.3 mm. Adjust the brake spacing approx. 0.2 mm by removing the washer 0. . 17 1 Checking the lamp terminal code 0 *The lamp terminal code 0 is provided at the back of the control box. The AC 6 V lamp can be connected with this lamp terminal code. CAUTION: Be sure to wrap the end of the cord with tape after disconnecting the lamp code. 0 ° 0