Brother International LS2300PRW Users Manual - English and Spanish - Page 15

While holding the thread as shown below, f pull it between the tension discs. Drawing up the lower thread Lightly hold the end of the upper thread. a 1 Guide the thread through the thread take-up g lever from right to left. a Upper thread While holding the end of the upper thread, b raise the needle to its highest position by turning the handwheel toward you (counterclockwise). a Thread take-up lever Put the thread behind the needle bar thread h guide above the needle. The thread can easily be passed behind the needle bar thread guide by holding the thread in your left hand, then feeding the thread with your right hand. Pull on the upper thread to draw up the lower c thread. a Needle bar thread guide Thread the needle from front to back and pull i out about 5 cm (2 inches) of thread. a 5 cm (2 inches) Note ● If the thread take-up lever is lowered, the upper thread cannot be wrapped around the thread take-up lever. Make sure you raise the presser foot lever and the thread take-up lever before you feed the upper thread. ● If you incorrectly feed the thread you may cause sewing problems. a Upper thread b Lower thread Pull out about 15 cm (6 inches) of both d threads and pull them toward the back of the machine under the presser foot. a Upper thread b Lower thread 14