Brother International MFC-9125CN Quick Setup Guide - English - Page 36

For Wireless Network Users Manual configuration from the control panel 19 Configure the wireless settings IMPORTANT You must have the wireless settings you wrote down for your network in step 18-b on page 29 before you proceed. a On your machine, press Menu, 7 (Network), 2 (WLAN), 2 (Setup Wizard). When WLAN Enable ? is displayed, press 1 to choose On. This will start the wireless setup wizard. Otherwise press Stop/Exit to exit from the wireless setup wizard. b The machine will search for available SSIDs. If a list of SSIDs is displayed, use the a or b key to choose the SSID you wrote down in step 18-b on page 29, then press OK. Go to step f. If your access point is set to not broadcast the SSID you will have to manually add the SSID name. Go to step c. Note • It will take several seconds to display a list of available SSIDs. • If a list of SSIDs is not displayed, make sure your access point is on. Move your machine closer to the access point and try starting from a again. c Press a or b to choose and press OK. Go to step d. d Enter the SSID you wrote down in step 18-b on page 29 using the dial pad to choose each letter or number. You can use d and c to move the cursor left and right. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on the dial pad seven times. The letters appear in this order: lower case, upper case and then numbers. (For more information, see Entering Text for Wireless Settings on page 45.) Press OK when you have entered all the characters. e Press a or b to choose Infrastructure, then press OK. f Use the a, b and OK keys to choose one of the options below: If your network is configured for Authentication and Encryption you must match the settings used for your network.  No Authentication or Encryption: Choose Open System, press OK then choose None for Encryption Type? and press OK. Then press 1 for Yes to apply your settings. Go to step k.  No Authentication with WEP Encryption: Choose Open System, press OK then use a or b to choose WEP for the Encryption Type? and press OK. Go to step g.  Authentication with WEP Encryption: Choose Shared Key and press OK. Go to step g.  Authentication with WPA/WPA2-PSK (TKIP or AES) Encryption: Choose WPA/WPA2-PSK and press OK. Go to step h.  Authentication with LEAP: Choose LEAP, press OK. Go to step i.  Authentication with EAP-FAST/NONE, EAP-FAST/MS-CHAPv2, EAP-FAST/GTC (TKIP or AES Encryption): Choose EAP-FAST/NONE, EAP-FAST/MSCHAP (EAP-FAST/MSCHAPv2) or EAP-FAST/GTC, press OK. Go to step j. 36