Brother International MFC-9125CN Quick Setup Guide - English - Page 37

For Wireless Network Users g Choose the appropriate key number and press OK. Enter the WEP key you wrote down in step 18-b on page 29 using the dial pad to choose each letter or number. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on the dial pad seven times. The letters appear in this order: lower case, upper case and then numbers. (For more information, see Entering Text for Wireless Settings on page 45.) Press OK when you have entered all the characters, then press 1 for Yes to apply your settings. Go to step k. h Press a or b to choose TKIP or AES for Encryption Type? and press OK. Enter the WPA/WPA2-PSK password you wrote down in step 18-b on page 29 using the dial pad to choose each letter or number. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on the dial pad seven times. The letters appear in this order: lower case, upper case and then numbers. (For more information, see Entering Text for Wireless Settings on page 45.) Press OK when you have entered all the characters, then press 1 for Yes to apply your settings. Go to step k. i Enter the user name and press OK. You can use d or c to move the cursor. For example, to enter the letter a, press the 2 key on the dial pad once. Enter the password and press OK, and then press 1 to apply your settings. Go to step k. (Use the chart on Entering Text for Wireless Settings on page 45.) j Press a or b to choose TKIP or AES for Encryption Type? and press OK. Enter the user name and press OK. You can use d or c to move the cursor. For example, to enter the letter a, press the 2 key on the dial pad once. Enter the password and press OK, and then press 1 to apply your settings. Go to step k. (Use the chart on Entering Text for Wireless Settings on page 45.) k Your machine will now try to connect to your wireless network using the information you have entered. If successful, Connected will appear briefly on the LCD. If your machine does not successfully connect to your network, verify your network settings collected in step 18-b on page 29, then repeat steps a to j to make sure you have entered the correct information. If your access point does not have DHCP enabled you will need to manually configure the IP address, subnet mask and gateway of the machine to suit your network. See the Network User's Guide for details. Wireless setup is now complete. A four level indicator at the right of your machine's LCD will show the wireless signal strength of your access point/router. To install the MFL-Pro Suite, continue to; For Windows® Users: Now go to step 20 on page 40 For Macintosh Users: Now go to step 20 on page 42 Windows® Macintosh Wireless Network 37