Brother International PE-400D Users Manual - English - Page 21
Start/stop - bobbin
View all Brother International PE-400D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
5. Guide the thread through the small hole in the side of the bob- bin from the inside. Align the groove in the bobbin with the spring on the shaft and place the bobbin on the bobbin winder shaft. While holding the thread end, push the bobbin winder shaft to the right. 1 1 Spring on the shaft 2 Groove of the bobbin 6. Set the speed to minimum. 2 7. While holding the thread end, press the "START/STOP" button. Wind the thread a few times around the bobbin and press the "START/STOP" button again. Trim the excess thread from the top of the bobbin after the machine stops. 2 1 18 8. Set the speed to maximum. 9. Press the "START/STOP" button. The bobbin will stop spin- ning when bobbin winding is finished. 10. When the bobbin stops spinning, press the "START/STOP" button to stop the sewing machine. 11. Push the bobbin shaft to the left. Remove the bobbin.