Brother International PE-400D Users Manual - English - Page 54
Bar Tacking
View all Brother International PE-400D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
BAR TACKING A Use for reinforcing the openings of poc kets, etc. 1 Bar tac k 1 1. Attach p resser foot "A" and set the size by measuring the area to be b ar tacked. 1 Scale 2 0.5 cm (13/64") 3 Length of bar tac k * 0.5 to 3 cm (13/64" to 1-3/16") is suitab le for bar tacking. 0.5 to 1 cm (13/64" to 3/8") is the nor mal size. 2. Position the poc ket as illustrated with the top of the poc ket facing you. 5 3 CAUTION - After the presser foot lever has been lowered, set the presser foot so that there is no gap be- hind the section marked with an "A", otherwise the size of the stitch will not be correct. To do " this, push the presser foot towards the back of the machine as shown in the figure. - Pass the thread underneath the presser foot. 3. Check the first needle drop point and lo wer the presser f oot. 1 2 mm (5/64") 5 4. Lower the buttonhole le ver and position it behind the metal 3 bracket on the b uttonhole f oot. 1 Metal bracket on b uttonhole f oot 51