Brother International S-7200C Instruction Manual - English - Page 78
Brother International S-7200C Manual
View all Brother International S-7200C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
14. TROUBLESHOOTING Error code E452 Head detector unit connection error Possible cause ・ Is the 6-pin head detector unit connector inside the control box disconnected? Press the power OFF switch, and then check that the 6-pin head detector unit connector is connected to connector P8 on the main P.C. board. E701 Abnormally high power supply voltage ・ Does the power supply voltage match the control box voltage specifications? Check that the voltage matches. ・ Is the power supply voltage abnormally high? Check the power supply voltage. ・ Problem with control box. Replace the control box. E705 Abnormally low power supply voltage ・ Is the power supply voltage abnormally low? Check the power supply voltage. ・ Problem with control box. Replace the control box. E710 Motor overcurrent ・ Is the electrical equipment connector inside the control box disconnected? Press the power OFF switch, and then check that the drive P.C. board connectors are connected to connectors P3 and P4 on the main P.C. board. ・ Problem with control box. Replace the control box. Page 10* * * ** * ** * ** E791 ・ This is displayed when there is overcurrent in any of the solenoids (thread trimming, thread wiping, quick reverse or presser lifter). Solenoid Check the resistances of the solenoids. * overcurrent ・ Problem with main P.C. board. Replace the control box. ** E901 ・ DIP switch No. 4 inside the control box is set to ON. Press the power OFF switch and set DIP switch No. 4 to OFF. * If an error code that is not listed above appears or if carrying out the specified remedy does not solve the problem, contact the place of purchase. 71 S-7200C