Canon PIXMA MP495 Manual - Page 722

Changing the Settings in the Wireless LAN Sheet Page 722 of 759 pages Use next IP address If no DHCP server functionality is available in your setup where you use the printer or you want to use a particular IP address, select this option to use a fixed IP address. Search dialog box 1. Detected Access Points The signal strength from the access point, encryption type, name of access point, and the radio channel can be confirmed. Important If you connect to a network that is not protected with security measures, there is a risk of disclosing data such as your personal information to a third party. Note Signal strength is displayed as follows. : Good : Fair : Poor Type of encryption is displayed as follows. Blank: No encryption WEP: WEP is set WPA: WPA is set WPA2: WPA2 is set 2. Update Click to update the list of access points when your target access point is not detected. If the target access point is set to the stealth mode, click Cancel to return to the previous screen and enter the access point's Service Set Identifier in SSID. Note Make sure that the access point is turned on. 3. Set Click to set the access point's SSID in SSID on the Wireless LAN sheet. Note Depending on your settings, WEP Details dialog box, WPA Details dialog box, or WPA2 Details dialog box appears when you click the Set button. In the dialog box, configure the details to use the same encryption settings set to the access point. Access points that cannot be used by this machine (including those configured to use different encryption methods) are displayed grayed out and cannot be configured.