Canon REALiS WX450ST Pro AV User Manual - Page 202

Replacing the Lamp Replacement Lamp This projector uses the following lamps. Lamp part no.: RS-LP08 Contact the Canon Customer Support Center when purchasing a replacement lamp. Precautions when replacing lamps that stop working If the illumination suddenly stops when the projector is in use or after you turn it on, the lamp may be broken. In this case, never attempt to replace the lamp by yourself. Always request service from the Canon Customer Support Center. Additionally, with ceiling-mounted projectors, the lamp may fall out when you open the lamp cover or while you are attempting to replace it. During replacement, stand to the side of the lamp cover, not directly under it. If the lamp breaks and any glass shards or other pieces get in your eyes or mouth, consult a doctor immediately. When replacing the lamp, turn off the projector, wait until the cooling fan stops, disconnect the power plug from the electrical outlet, and let the projector stand for at least 1 hour. Otherwise, you may get burned because the main unit is very hot immediately after the projector is turned off. • Be sure to use the specified lamp. • Contact the Canon Customer Support Center for further information. This can also be purchased from the Canon website. • Do not touch the inner glass surface when you replace the lamp. Doing so may cause deterioration to the projector's performance. • Be sure to handle the lamp carefully and correctly since it may break during use if it has been scratched or subjected to impact. If the lamp breaks, contact the Canon Customer Support Center or follow the instructions on P26 and P27. • When replacing the lamp, do not remove any screws other than those specified. Replacing the Lamp 1 Turn off the projector power and remove the power plug. 2 Press the lamp cover release button to release the lock. 202