Canon imageFORMULA ScanFront 400 ScanFront 400 Setup and Operation Guide - Page 67
ScanFront 400 INSTRUCTIONS, Make sure the selected address has a checkmark, and then press [Next].
![]() |
View all Canon imageFORMULA ScanFront 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
IMPORTANT An address is not selected as an address to send data to if there is no checkmark, even if the background is shaded. 4. Make sure the selected address has a checkmark and then press [Next]. Hint When a different type of address is selected, you can confirm the selected address by pressing [Selected address] in the Address type drop-down list. The Scan / Send Settings screen appears. 5. Set the scan conditions. For details, refer to "Scan / Send Settings" on p. 85 of the ScanFront 400 INSTRUCTIONS. IMPORTANT When you use a job button for scanning, the subsequent procedure varies as follows in accordance with the job button settings. For details, see "Registering New Job Buttons" on p. 89. • If [When you select this Job Button] is set to [Skip Scan Setting Screen] and you press a job button, scanning is started without displaying the Scan / Send Settings screen of Step 4. • If [Send the files immediately after scanning] is set to [ON], scanning ends without displaying the continue to scan confirmation screen of Step 7 and then the address confirmation screen of Step 10 appears. • If [Confirm addresses before sending] is set to [OFF], the image is sent without displaying the address confirmation screen of Step 10 and the operation ends. Chapter 4 Operating Procedures 67
![](/manual_guide/products/canon-imageformula-scanfront-400-scanfront-400-setup-operation-guide-b7ff4c9/67.png)