Cisco 5510 Getting Started Guide - Page 161

Chapter 12 Scenario: Site-to-Site VPN Configuration Step 3 Click Next to continue. Implementing the Site-to-Site Scenario Specifying Hosts and Networks Identify hosts and networks at the local site that are permitted to use this IPsec tunnel to communicate with hosts and networks on the other side of the tunnel. Specify hosts and networks that are permitted access to the tunnel by clicking Add or Delete. In the current scenario, traffic from Network A (10.10.10.0) is encrypted by Security Appliance 1 and transmitted through the VPN tunnel. In addition, identify hosts and networks at the remote site to be allowed to use this IPsec tunnel to access local hosts and networks. Add or remove hosts and networks dynamically by clicking Add or Delete respectively. In this scenario, for Security Appliance 1, the remote network is Network B (10.20.20.0), so traffic encrypted from this network is permitted through the tunnel. In Step 5 of the VPN Wizard, perform the following steps: Step 1 Step 2 Enter the IP address of local networks to be protected or not protected, or click the ellipsis (...) button to select from a list of hosts and networks. Enter the IP address of remote networks to be protected or not protected, or click the ellipsis (...) button to select from a list of hosts and networks. 78-19186-01 Cisco ASA 5500 Series Getting Started Guide 12-9