Cisco 5510 Getting Started Guide - Page 202
Cabling 4GE SSM Interfaces
UPC - 882658094767
View all Cisco 5510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
Cabling 4GE SSM Interfaces Chapter 15 Configuring the 4GE SSM for Fiber Cabling 4GE SSM Interfaces To cable 4GE SSM interfaces, perform the following steps for each port you want to connect to a network device: Step 1 To connect an RJ-45 (Ethernet) interface to a network device, perform the following steps for each interface: a. Locate a yellow Ethernet cable from the accessory kit. b. Connect one end of the cable to an Ethernet port on the 4GE SSM as shown in Figure 15-1. Figure 15-1 Connecting the Ethernet port POWER STATUS 143597 MMGGMMTT UUSSBB22 USB1 LNK 3 2 1 Cisco SSM-4GE 0 SPD 1 1 RJ-45 (Ethernet) port Step 2 c. Connect the other end of the cable to your network device. (Optional) If you want to use an SFP (fiber optic) port, install and cable the SFP modules as shown in Figure 15-2: a. Insert and slide the SFP module into the SFP port until you hear a click. The click indicates that the SFP module is locked into the port. b. Remove the optical port plugs from the installed SFP. c. Locate the LC connector (fiber optic cable) in the 4GE SSM accessory kit. d. Connect the LC connector to the SFP port. 15-2 Cisco ASA 5500 Series Getting Started Guide 78-19186-01