Cisco 5510 Getting Started Guide - Page 203
Setting the 4GE SSM Media Type for Fiber Interfaces (Optional
UPC - 882658094767
View all Cisco 5510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Chapter 15 Configuring the 4GE SSM for Fiber Setting the 4GE SSM Media Type for Fiber Interfaces (Optional) Figure 15-2 Connecting the LC Connector POWER STATUS 143647 MMGGMMTT UUSSBB22 USB1 LNK 3 2 1 Cisco SSM-4GE 0 SPD 2 1 1 LC connector 2 SFP module e. Connect the other end of the LC connector to your network device. After you have attached any SFP ports to your network devices, you must also change the media type setting for each SFP interface. Continue with the following procedure, "Setting the 4GE SSM Media Type for Fiber Interfaces (Optional)." Setting the 4GE SSM Media Type for Fiber Interfaces (Optional) If you are using fiber interfaces, for each SFP interface you must change the media type setting from the default setting (Ethernet) to Fiber Connector. Note Because the default media type setting is Ethernet, you do not need to change the media type setting for Ethernet interfaces you use. 78-19186-01 Cisco ASA 5500 Series Getting Started Guide 15-3