Cisco 5510 Getting Started Guide - Page 40
Removing the Fiber Port Plug, Install the SFP module - router
UPC - 882658094767
View all Cisco 5510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Connecting Interface Cables Chapter 3 Installing the ASA 5550 Step 6 b. Connect the other end of the Ethernet cable to a network device, such as a router, switch or hub. Connect to fiber Ethernet ports to be used for network connections. Note Slot 1 contains four copper Ethernet ports and four fiber Ethernet ports. You can use both types of ports, but you can only have a total of four Slot 1 ports in use at a time. For example, you could use two copper Ethernet ports and two fiber Ethernet ports. For each fiber port you want to use, perform the following steps: a. Install the SFP module: - Insert and slide the SFP module into the fiber port until you hear a click. The click indicates that the SFP module is locked into the port. - Remove the port plug from the installed SFP as shown in Figure 3-14. Figure 3-14 1 Removing the Fiber Port Plug 2 STATUS 143146 1 Port plug 2 SFP module b. Connect the LC connector to the SFP module as shown in Figure 3-15. 3-18 Cisco ASA 5500 Series Getting Started Guide 78-19186-01