Cisco 7906G Administration Guide - Page 182
Message, Description, Possible Explanation and Action, Adding Phones
![]() |
UPC - 882658089343
View all Cisco 7906G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Status Menu Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone Table 7-3 Status Messages on the Cisco Unified IP Phones 7906G and 7911G Message BootP server used CFG file not found Description The phone obtained its IP address from a BootP server rather than from a DHCP server. The name-based and default configuration file was not found on the TFTP Server. CFG TFTP Size Error The configuration file is too large for file system on the phone. Possible Explanation and Action None. This message is informational only. The configuration file for a phone is created when the phone is added to the Cisco Unified Communications Manager database. If the phone has not been added to the Cisco Unified Communications Manager database, the TFTP server generates a CFG File Not Found response. • Phone is not registered with Cisco Unified Communications Manager. You must manually add the phone to Cisco Unified Communications Manager if you are not allowing phones to auto-register. See the ""Adding Phones with Cisco Unified Communications Manager Administration" section on page 2-14 for details. • If you are using DHCP, verify that the DHCP server is pointing to the correct TFTP server. • If you are using static IP addresses, check configuration of the TFTP server. See the "Network Configuration Menu" section on page 4-7for details about assigning a TFTP server. Power cycle the phone. Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1 7-6 OL-14585-01
![](/manual_guide/products/cisco-7906g-administration-guide-147573f/182.png)