Cisco 7906G Administration Guide - Page 52

Overview of Configuring and Installing Cisco Unified IP Phones Chapter 1 An Overview of the Cisco Unified IP Phone Table 1-7 Checklist for Installing the Cisco Unified IP Phones 7906G and 7911G (continued) Installation Step and Purpose Step 4 Configure these network settings on the phone by choosing Settings > Network Configuration. Note Unlock the phone settings before making these changes from the phone. For More Information See the "Configuring Startup Network Settings" section on page 3-16. See the "Network Configuration Menu" section on page 4-7. To enable DHCP: 1. Set DHCP Enabled to Yes. 2. To use an alternate TFTP server, set Alternate TFTP Server to Yes. Enter IP address for TFTP Server 1. To disable DHCP: 1. Set DHCP Enabled to No. 2. Enter static IP address for phone. 3. Enter subnet mask. 4. Enter default router IP addresses. 5. Enter domain name where phone resides. 6. Set Alternate TFTP Server to Yes Enter IP address for TFTP Server 1. Using DHCP-The IP address is automatically assigned and the Cisco Unified IP Phone is directed to a TFTP Server. Note Consult with the network administrator if you need to assign an alternative TFTP server instead of using the TFTP server assigned by DHCP. Without DHCP-You must configure the IP address, TFTP server, subnet mask, domain name, and default router locally on the phone. 1-34 Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1 OL-14585-01