Cisco 7906G Administration Guide - Page 70

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network Using Cisco Unified IP Phones with Different Protocols Step 2 Step 3 • To provision the phone by using the Bulk Administration Tool (BAT), choose the appropriate phone model and choose SIP from BAT. • To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration window in Cisco Unified Communications Manager Administration. Refer to the Cisco Unified Communications Manager Administration Guide for more information about Cisco Unified Communications Manager configuration. Refer to Bulk Administration Tool Administration Guide for more information about using BAT. If you are not using DHCP in your network, configure the network parameters for the phone. See the "Configuring Startup Network Settings" section on page 3-14. Power cycle the phone. Converting an In-Use Phone from SCCP to SIP You can use the Bulk Administration Tool (BAT) to convert a phone that is in use in your network from SCCP to SIP. To access BAT from Cisco Unified Communications Manager Administration, choose Bulk Administration > Phones > Migrate Phones > SCCP to SIP. For more information, refer to the "Migrating Phones" chapter Bulk Administration Tool Administration Guide. Converting an In-Use Phone from SIP to SCCP To convert a phone that is in use in your network from SIP to SCCP, perform these steps. For more information, Cisco Unified Communications Manager Administration Guide. Procedure Step 1 In Cisco Unified Communications Manager Administration, delete the existing SIP phone from the Cisco Unified Communications Manager database. 2-16 Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.1 OL-14585-01