Cisco AIR-AP1020 Quick Start Guide - Page 25

Installation and Configuration Mounting the Cisco Aironet 1000 Series Lightweight Access Points Figure 8 Attaching the Cisco Aironet 1000 Series Lightweight Access Point and Ceiling-Mount Base 135664 1. Copy the MAC address(es) from the label(s) on the Cisco Aironet 1000 Series lightweight access point onto the corresponding location on the map. MAC addresses have the format 00xxxxxxxxxx. 2. Attach the ceiling-mount base to the bottom of the Cisco Aironet 1000 Series lightweight access point using the factory-supplied machine screws and washers. 3. Position the ceiling-mount base so its keyhole slots are partly on the drywall, sheet metal, or other screw heads installed in "Preparing Mounting Locations." Note If the screws do not securely hold the ceiling-mount base, remove the Cisco Aironet 1000 Series lightweight access point and adjust the screws until they hold the ceiling-mount base securely. 4. Attach the cables to the sides of the Cisco Aironet 1000 Series lightweight access point. Note When the Cisco Aironet 1000 Series lightweight access point is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the Cisco Aironet 1000 Series lightweight access point is broadcasting its beacon signal(s). When this happens, complete the installation as quickly as possible to remove yourself from within 8 in. (20 cm) of the Cisco Aironet 1000 Series lightweight access point to comply with FCC RF radiation exposure guidelines. 5. Slide the ceiling-mount base onto the drywall, sheet metal, or other screw heads until it fits snugly in place. You installed the access point. Repeat "Mounting the Cisco Aironet 1000 Series Lightweight Access Points" for each location, and then continue with "Returning MAC Information." AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide 78-17147-01 15