Cisco AIR-AP1020 Quick Start Guide - Page 37

Appendix A Planning Notes RF Radiation Hazard Warning RF Radiation Hazard Warning To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such that the antenna of the device will be greater than 20 cm (8 in.) from all persons. Using higher gain antennas and types of antennas not covered under the FCC certification of this product is not allowed. Installers of the radio and end users of the Cisco Wireless LAN Solution must adhere to the installation instructions provided in this manual. Non-Modification Statement Non-Modification Statement Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unauthorized antennas, modifications, or attachments could damage the badge and could violate FCC regulations and void the user's authority to operate the equipment. External Antennas The AIR-AP1020-A-K9, AIR-AP1020-E-K9, AIR-AP1020-J-K9, AIR-AP1030-A-K9, AIR-AP1030-E-K9, and AIR-AP1030-J-K9 Cisco Aironet 1000 Series IEEE 802.11a/b/g lightweight access points can be used with external antennas with the following characteristics: • 5 GHz patch antenna: 6 dBi net gain. • 2.4 GHz patch antenna: 6 dBi net gain. Deployment Statement This product is certified for indoor deployment only. Do not install or use this product outdoors. EU Regulatory Information Compliance Information for Cisco Aironet 1000 Series IEEE 802.11a/b/g lightweight access points: 1. Standards met: - Radio: EN 301 328, EN 301 893 - EMC: EN 301489-1, EN 301 489-17 - Safety: EN 60950 - RF Safety: EN 50371 2. CE Marking: Cisco Aironet 1000 Series 802.11a/b/g lightweight access points are identified with this CE marker: 3. EU Country Restriction: Note • The Cisco Aironet 1000 Series IEEE 802.11a/b/g lightweight access point is intended for indoor use only. AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide 78-17147-01 A-5