Cisco AIR-AP1210 Hardware Installation Guide - Page 70
Removing a Blank Spacer Card
UPC - 746320804330
View all Cisco AIR-AP1210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Removing a Blank Spacer Card Chapter 7 2.4-GHz Radio Upgrade Removing a Blank Spacer Card When your access point is not factory-configured with a 2.4-GHz radio, it contains a blank spacer card in the internal mini-PCI connector. You must remove the blank spacer card prior to installing a new 2.4-GHz radio card. Caution Handle all components carefully and observe all ESD precautions. The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper handling. To remove the blank spacer card from the mini-PCI connector, following these steps: Step 1 Push the card-retaining clips (on each side of card) away from the card (see Figure 7-2). When released, the board springs up. Figure 7-2 Location of Retaining Clips on Blank Spacer Card 1 2 31 74248 1 Card-retaining clips 2 Antenna connector (white wire) 3 Antenna connector (black wire) Step 2 Carefully bend the card near the slots in opposite directions to provide enough clearance to remove the antenna wires. Cisco Aironet 1200 Series Access Point Hardware Installation Guide 7-4 OL-4310-01