Cisco AIR-AP1210 Hardware Installation Guide - Page 72
Location of Retaining Clips on 2.4-GHz Radio Card, Step 2
UPC - 746320804330
View all Cisco AIR-AP1210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Removing a 2.4-GHz Radio Chapter 7 2.4-GHz Radio Upgrade Step 2 Remove the 2.4-GHz radio card from the mini-PCI connector by performing the following operations: a. Push the card-retaining clips (on each side of card) away from the card (see Figure 7-3). When released, the radio card springs up (see Figure 7-4). Figure 7-3 Location of Retaining Clips on 2.4-GHz Radio Card 1 1 MAIN AUX 74253 1 Card-retaining clips Step 3 b. Grasp the radio card only on the edges, being careful not to touch components on the board or the gold connector pins. c. Remove the 2.4-GHz card from the mini-PCI connector. Place the removed 2.4GHz radio card into an anti-static bag. For instructions on installing a new radio card, go to the "Installing a 2.4-GHz Radio" section. Cisco Aironet 1200 Series Access Point Hardware Installation Guide 7-6 OL-4310-01