Cisco AIR-AP1220B-A-K9 Hardware Installation Guide - Page 57
Opening the Access Cover
UPC - 746320719191
View all Cisco AIR-AP1220B-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Chapter 5 2.4-GHz Radio Upgrade Opening the Access Cover Opening the Access Cover To open the 2.4-GHz radio access cover, follow the steps below: Step 1 Step 2 Step 3 Step 4 Step 5 Remove all cables and power connections from the access point. Remove all static generating items from the work area, such as plastic material, styrofoam cups, and other similar items. Place the access point and the new 2.4-GHz radio (in its antistatic bag) on an antistatic work surface. Discharge any static buildup on your body by touching a grounded surface (antistatic work surface) before proceeding. Position the access point so that the bottom cover is facing up. Caution The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper handling. Step 6 Remove the bottom access cover (see Figure 5-1) using the T-10 tamper-resistant Torx L-wrench provided with your Cisco radio card. Figure 5-1 Location of 2.4-GHz Radio Access Cover Screw 1 74458 1 Access Cover Screw If your access point was not configured with a 2.4-GHz radio, go to the "Removing a Blank Spacer Card" section. If you are replacing an existing 2.4-GHz radio, go to the "Removing a 2.4-GHz Radio" section. OL-2155-02 Cisco Aironet 1200 Series Access Point Hardware Installation Guide 5-3