Cisco AIR-AP1220B-A-K9 Hardware Installation Guide - Page 64
Overview, Unpacking the Radio Module, Removing the 5-GHz Radio Access Cover
![]() |
UPC - 746320719191
View all Cisco AIR-AP1220B-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Overview Chapter 6 5-GHz Radio Module Upgrade Overview This section provides instructions for upgrading the access point 5-GHz radio module. The following operations summarize the upgrade procedure: 1. Remove all cables and power connections from the access point. 2. Place your access point on a flat surface. 3. For an access point without the 5-GHz radio feature, remove the 5-GHz radio access cover. 4. For an access point with the 5-GHz radio feature, remove the existing 5-GHz radio module. 5. Install the new 5-GHz radio module. Unpacking the Radio Module Each 5-GHz radio module is shipped with the following items: • Quick start guide • A product registration card • A T-10 tamper-resistant Torx L-wrench • A 5-GHz radio product compliance label If anything is missing or damaged, contact your Cisco representative for support. Removing the 5-GHz Radio Access Cover To remove the 5-GHz radio access cover, follow the instructions below: Step 1 Remove all cables and power connections from the access point. Step 2 Place the access point on a flat surface so that the unit is upright with the front end facing you. Cisco Aironet 1200 Series Access Point Hardware Installation Guide 6-2 OL-2155-02
![](/manual_guide/products/cisco-airap1220bak9-hardware-installation-guide-bf8cbb1/64.png)