Cisco AIR-AP1220B-A-K9 Hardware Installation Guide - Page 65
Removing a 5-GHz Radio Module
UPC - 746320719191
View all Cisco AIR-AP1220B-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 6 5-GHz Radio Module Upgrade Removing a 5-GHz Radio Module Step 3 Remove the 5-GHz access cover (see Figure 6-1) using the supplied Torx L-wrench. Figure 6-1 5-GHz Radio Access Cover 121 74632 1 Access Cover Screws 2 Access Cover Removing a 5-GHz Radio Module To remove the 5-GHz radio module, follow the instructions below: Step 1 Step 2 Step 3 Remove all cables and power connections from the access point. Place the access point on a flat surface so that the unit is upright with the front end facing you. Unscrew the two mounting screws using the supplied Torx L-wrench (Figure 6-2). Figure 6-2 5-GHz Radio Module 1 1 2 3 74631 1 Mounting screws 2 5-GHz radio module antenna 3 Access point Note Do not attempt to remove the mounting screws from the module; they are captured in the module housing. OL-2155-02 Cisco Aironet 1200 Series Access Point Hardware Installation Guide 6-3