Cisco AIR-AP1220B-A-K9 Hardware Installation Guide - Page 67
Installing a 5-GHz Radio Module
UPC - 746320719191
View all Cisco AIR-AP1220B-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Chapter 6 5-GHz Radio Module Upgrade Installing a 5-GHz Radio Module Installing a 5-GHz Radio Module To install a new 5-GHz radio module into your access point, follow the steps below: Step 1 Step 2 Step 3 Before you can install a new 5-GHz radio module, you must remove the access cover or an existing 5-GHz radio module (refer to "Removing the 5-GHz Radio Access Cover" or "Removing a 5-GHz Radio Module"). Place the access point on a flat surface so that the unit is upright with the front end facing you. Grasp the new 5-GHz radio module by it's base (with the antenna pointing up) and insert the card into the access point's card-bus slot (see Figure 6-4). Figure 6-4 Installing a 5-GHz Radio Module 1 2 34 74604 1 Access point 2 5-GHz radio module antenna 3 Access point card-bus slot 4 5-GHz radio card Step 4 Push the 5-GHz radio module into the slot until you hear a slight click. OL-2155-02 Cisco Aironet 1200 Series Access Point Hardware Installation Guide 6-5