Cisco WRV200 User Guide - Page 7

Chapter 2 Networking and Security Basics Chapter 2: Planning Your Wireless Network Network Topology A wireless local area network (WLAN) is exactly like a regular local area network (LAN), except that each computer in the WLAN uses a wireless device to connect to the network. Computers in a WLAN share the same frequency channel and SSID, which is an identification name shared by the wireless devices belonging to the same wireless network. Ad-Hoc versus Infrastructure Mode Unlike wired networks, wireless networks have two different modes in which they may be set up: infrastructure and ad-hoc. An infrastructure configuration is a WLAN and wired LAN communicating to each other through an access point. An ad-hoc configuration is wirelessequipped computers communicating directly with each other. Choosing between these two modes depends on whether or not the wireless network needs to share data or peripherals with a wired network or not. If the computers on the wireless network need to be accessible by a wired network or need to share a peripheral, such as a printer, with the wired network computers, the wireless network should be set up in Infrastructure mode. The basis of Infrastructure mode centers around an access point or wireless router, such as the Wireless-G VPN Router, which serves as the main point of communications in a wireless network. The Router transmits data to PCs equipped with wireless network adapters, which can roam within a certain radial range of the Router. You can arrange the Router and multiple access points to work in succession to extend the roaming range, and you can set up your wireless network to communicate with your Ethernet hardware as well. If the wireless network is relatively small and needs to share resources only with the other computers on the wireless network, then the Ad-Hoc mode can be used. Ad-Hoc mode allows computers equipped with wireless transmitters and receivers to communicate directly with each other, eliminating the need for a wireless router or access point. The drawback of this mode is that in AdHoc mode, wireless-equipped computers are not able to communicate with computers on a wired network. And, of course, communication between the wireless-equipped computers is limited by the distance and interference directly between them. Wireless-G VPN Router with RangeBooster Network Layout The Wireless-G VPN Router has been specifically designed for use with both your 802.11b and 802.11g products. Now, products using these standards can communicate with each other. The Wireless-G VPN Router is compatible with all 802.11g and 802.11n adapters, such as the Notebook Adapters (WPC4400N, WPC200) for your laptop computers, PCI Adapter (WMP200) for your desktop PC, and USB Adapter (WUSB200, USB1000) when you want to enjoy USB connectivity. The Router will also communicate with Wireless Ethernet Bridges (WET200). When you wish to connect your wireless network with your wired network, you can use the Router's four LAN ports. To add more ports, any of the Router's LAN ports can be connected to any Linksys Business Series switch (such as the SLM series or SRW series switches). With these, and many other, Linksys products, your networking options are limitless. Go to the Linksys website at www.linksys.com for more information about products that work with the Wireless-G VPN Router with RangeBooster. Network Diagram