Cisco WVC80N User Guide - Page 20
Setup > Motion Detection, E-Mail Alert - audio
View all Cisco WVC80N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Chapter 3 Advanced Configuration with the Web-based Utility Audio Port To change the Audio Port, enter the new port number (even values only, from 1024 to 65534) in the field provided. The default Audio Port, 2242, can be used for multicasting and does not normally need to be reconfigured. If this port number needs to be changed, contact your network administrator. Time to Live Enter the maximum length of time (usually measured as the number of network routers that can be passed before the data arrives at its destination or is dropped) within which the data must reach its destination. The value must be from 1 to 255. The default value is 16. To save your changes, click Apply. To cancel any unsaved changes, click Cancel. To get additional information about the screen's features, click Help. Setup > Motion Detection The Setup > Motion Detection screen allows you to configure the Camera's motion detection settings. Setup > Motion Detection Trigger Motion Detection Enable Motion Detection Check this box to enable Motion Detection. Attachment Type Select the type of attachment to be sent, either JPEG or Video. If JPEG is selected, a series of images will be attached to the e-mail as individual files. If Video is selected, a single video file will be attached. Frame Rate If the Attachment Type field is set to JPEG, select the frame rate (number of frames to be captured per second), from 1 to 5. The default value is 1. Video Format If the Attachment Type is set to Video, select the video format, either ASF, MPEG-4, or 3GP. Pre-Capture Length This refers to video footage up to the moment when motion is detected. Select how many seconds' worth of this video will be saved. This value must be between 0 and 4 seconds. Post-Capture Length Select how many seconds' worth of video will be saved starting from the moment motion is detected. This value must be between 1 and 5 seconds. Interval Enter the time in minutes that must pass between motion detection events. Valid values are 0-5, 10, or 15. The default is 2. A value of 0 indicates no delay between events. Action(s) Select the action(s) to be performed upon motion detection. Select E-Mail to send an e-mail with a video attachment to a selected recipient., or select FTP to send the video to a selected FTP server. E-Mail Alert If the Action(s) field is set to E-Mail, fill in the following fields: Send To Enter the e-mail address where e-mail will be sent upon motion detection. You can optionally specify up to three addresses. Show "From" as Enter the e-mail address to be used as the From field in the e-mail to be sent. Subject Enter the Subject field for the e-mail, consisting of 48 alphanumeric characters or less. SMTP Port Number Enter the SMTP port number from 1 to 65535. The default is 25. SMTP Mail Server If you want to use an SMTP mail server, check the box next to Specify a SMTP Mail Server. Then enter the mail server's name in the field provided. My Mail Server Requires Authentication If you are using an SMTP mail server that requires authentication (you must log in with a username and password), check this box, then fill in the Account Name and Password fields. Test E-Mail Click this button to send a test e-mail to the address indicated by the Send To field. FTP If the Action(s) field is set to FTP, fill in the following fields: FTP Server Enter the FTP server name. Port Enter the FTP server's port number. Login Name and Password Enter the login name and password for the account on the FTP server. Passive Mode Select Enable (default) to enable passive mode, or Disable to disable it. File Path Name Enter the path to the location where the file will be saved on the FTP server. Wireless-N Internet Home Monitoring Camera 19