Compaq Armada e500 Compaq Armada E500 Series Reference Guide - Page 192

Telecom '111' Emergency Service. - service manual

Get Compaq Armada e500 - Notebook PC PDF manuals and user guides View all Compaq Armada e500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 192 highlights

This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There is no guarantee that Telecom lines will always continue to support pulse dialing. Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to bell tinkle or noise and may also cause a false answer condition. Should such problems occur, the user should not contact the Telecom Faults Service. Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. The associated equipment shall be set to operate within the following limits for compliance with Telecom's Specifications: a) There shall be no more than 10 call attempts to the same number within any 30-minute period for any single manual call initiation, and b) The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next attempt. Where automatic calls are made to different numbers, the equipment shall go on-hook for a period of not less than 5 seconds between the end of one attempt and the beginning of the attempt. The equipment shall be set to ensure that calls are answered between 3 and 30 seconds of receipt of ringing (S0 set between 2 and 10). This ensures: a) A person calling your modem will hear a short burst of ringing before the modem answers. This confirms that the call has been successfully switched through the network. b) Caller identification (which occurs between the first and second ring cadences) is not destroyed. This equipment does not fully meet Telecom's impedance requirements. Performance limitations may occur when used in conjunction with some parts of the network. Telecom will accept no responsibility should difficulties arise in such circumstances. This equipment should not be used under any circumstances which may constitute a nuisance to other Telecom customers. This equipment shall not be set to make automatic calls to the Telecom '111' Emergency Service. Regulatory Notices B-11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
Regulatory Notices
B-11
This device is equipped with pulse dialing, while the Telecom
standard is DTMF tone dialing. There is no guarantee that
Telecom lines will always continue to support pulse dialing.
Use of pulse dialing, when this equipment is connected to the
same line as other equipment, may give rise to bell tinkle or noise
and may also cause a false answer condition. Should such
problems occur, the user should not
contact the Telecom Faults
Service.
Some parameters required for compliance with Telecom’s
Telepermit requirements are dependent on the equipment (PC)
associated with this device. The associated equipment shall be set
to operate within the following limits for compliance with
Telecom’s Specifications:
a)
There shall be no more than 10 call attempts to the same
number within any 30-minute period for any single manual
call initiation, and
b)
The equipment shall go on-hook for a period of not less than
30 seconds between the end of one attempt and the
beginning of the next attempt.
Where automatic calls are made to different numbers, the
equipment shall go on-hook for a period of not less than 5
seconds between the end of one attempt and the beginning of the
attempt.
The equipment shall be set to ensure that calls are answered
between 3 and 30 seconds of receipt of ringing (S0 set between 2
and 10). This ensures:
a)
A person calling your modem will hear a short burst of
ringing before the modem answers. This confirms that the
call has been successfully switched through the network.
b)
Caller identification (which occurs between the first and
second ring cadences) is not destroyed.
This equipment does not fully meet Telecom’s impedance
requirements. Performance limitations may occur when used in
conjunction with some parts of the network. Telecom will accept
no responsibility should difficulties arise in such circumstances.
This equipment should not be used under any circumstances
which may constitute a nuisance to other Telecom customers.
This equipment shall not be set to make automatic calls to the
Telecom ‘111’ Emergency Service.