Compaq ProLiant 5000 ProLiant Server Troubleshooting Guide - Page 233
failed Set Block Mode, Array - Performance
View all Compaq ProLiant 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
POST Error Messages Table C-13: 1700 Series POST Error Messages continued Error Code Audible Beeps Probable Source of Problem 1728-Drive ArrayAbnormal Shut-Down Detected With WriteCache None There is no array accelerator battery backup on this array controller but caching was enabled. Any data that may have been in array accelerator memory has been lost due to the controller power loss. 1729-Slot 1 Drive Array - Performance Optimization Scan In Progress. RAID 4/5/ADG performance may be higher after completion. None RAID 4/5/ADG parity drive(s) are being initialized. 1730-Fixed Disk 0 does not support DMA Mode 1731-Fixed Disk 1 does not support DMA Mode. 1740-Fixed Disk 0 failed Set Block Mode command 1741-Fixed Disk 1 failed Set Block Mode command 1750- Fixed Disk X failed ID command 1750-Fixed Disk X failed Identify command None None None None None None Fixed disk drive error detected. Fixed disk drive error detected. Fixed disk drive error detected. Fixed disk drive error detected. Fixed disk drive error detected. Fixed disk drive error detected. Action Restore data from backup. This message is normal following the initial configuration of RAID 4 or RAID 5 logical drives. Performance of the controller improves after the parity data has been initialized by ARM (an automatic process that runs in the background on the controller). Run the server setup utility and correct. Run the server setup utility and correct. Run the server setup utility and correct. Run the server setup utility and correct. Run the server setup utility and correct. Run the server setup utility and correct. continued HP Servers Troubleshooting Guide C-53