Craftsman 24838 Operation Manual - Page 12
STEP18:SEE Turnthedutch/idler, assembly, rightsideup.
View all Craftsman 24838 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
STEP18: (SEEFIGURE17) * Turnthedutch/idlear ssemblyrightsideup. * Slightly loosen the hex bolt next to the flat idler pulley. Install the drive belt down between timehex bolt and the flat idler pulley with the fiat side of the belt against the pulley Retighten the hex bolt. * Loop the belt around the large v-pulley, placing it between the v-pulley and the hex bolt next to the pulley. HEX BOLTS FLATIDLER PULLEY DRIVE BELT FIGURE 17 Did you choose the correct drive belt for your tractor? Using the wrong length belt may cause premature bearing or belt failure. STEP 20: (SEE FIGURE 19) • Assemble the drive belt onto the engine pulley first and then onto the large pulley on top of the c_utch/ idler assembly. Place the belt to the inside of the idler pulley and the belt keeper bolt located beside the large pulley • Place tension on the belt by pulling the left side tensioning chain (PP) out as far as the 3/32" hairpin cotter in the chain will allow. Secure the chain in this position by inserting a 1/8" hairpin cotter (KK) through the chain. IMPORTANT: Do Not assemble the drive belt around the outside of the keeper bolt beside the large pulley • Go to step 48 Oh page 21. CLUTCH/IDLER ASSEMBLY PULLEY 1/8" HAIRPIN COTTER (KK) STEP 19: (SEE FIGURE 18) * Attach the clutch/idler assembly to the tractor frame Hook the notched suspension arms onto the two shoulder bolts (Q) assembled to the outside of the tractor frame. Lift the front of the assembly and attach it to the R.H. and L.H. hanger brackets using two pivot lock pins (MM) and 1/8" hairpin cotters (KK). PIVOT LOCK PIN (MM) LH. HANGER BRACKET 1/8"HAIRPIN COTTER(KK) /. SHOULDER BOLT(Q) FIGURE 19 VIEWED FROM UNDERNEATH FIGURE 18 VIEWED FROM LEFT SIDE 12