Craftsman 24838 Operation Manual - Page 21
Cable - snowthrower
View all Craftsman 24838 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
ASSEMBLY OFTHE SNOWTHROWER STEP 48: (SEE FIGURE 47) * Place the lift handle into the lift bracket on the right side of the snow thrower. Fasten the handle to the bracket using two 5/16" X 1-3/4" he× bolts (D) and 5/16" Ny[ock nuts (CO). LIFT HANDLE \, STEP 50: (SEE FIGURE 49) • Tilt the snow thrower back down to the ground • Remove the nylon tie which fastens the auger drive belt to the discharge housing, leaving the belt assembled around the pulleys. • Remove the nylon tie which fastens the chute c_ank rod to the crank rod support tube. • Assemble the crank rod support tube to the bracket on the left side of the discharge housing using two 5/16" x 1-1/4" carriage bolts (M), and 5/16" Nylock nuts (CO). DISCHARGE HOUSING _, ', X, ,\ 5/16" NYLOCK NUT (CC) FIGURE 47 5/16" x 1-3/4" HEX BOLT (D) LIFT BRACKET RIGHT SIDE VIEW NOTE: Be sure the lift release cable's plastic covering stays inserted into the trigger assembly for the next step STEP 49: (SEE FIGURE 48) * Push tbe lift handle down into the locked position. Insert the end of the cable wire into the hole in the lift rod Place the threaded fitting into the slot in the lift bracket, with one bex nut above and one hex nut a_d the _ock washer below the s_ot.Tighten the nuts, adjusting them to eliminate slack in the cable wire. Refer also to the Service and Adjustments section on page 29 in this manual. HINT: For easier assembly of the lift release cable, tilt the snow thrower forward onto the spiral auger •• CRANK ROD 5t16" NYLOCK NUT (CC) .SUPPORT TUBE FIGURE 49 LEFT SIDE ViEW STEP 51: (SEE FIGURE 50) * Attach the chute tilt control assembly to the top side ot the crank support tube using two 5/16" x 1-3/4" carriage bolts (L), bowed washers (Y) and 5/16" Nylock nuts (CC). LIFT RELEASE CHUTE CRANK ROD "_ CRANK SUPPORT TUBE _ TILT CONTROL HANDLE ----="-_ _/-TRIGGER ASSEMBLY " _._HEXNUT _ _, [_ 5/16" _ 1-3/4 _ CARRIAGE B,,OL_ BOWEDWASHER{Y) _ I \ _ WASBER ]/ i HERXDT 5/16" NYLOCK NUT f,CC) / /\ CABLE FIGURE 50 .... _; CONTROL ASSTEILMTBLY "_ LEFT SIDEVIEW FIGURE 48 RIGHT SIDE VIEW 21