Craftsman 24838 Operation Manual - Page 18
Step 39: See
View all Craftsman 24838 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
STEP 39: (SEE FIGURE 39) * Remove the engine pulley keeper from the side of the tractor frame by removing the washer and nut that secure the keeper Attach the new pulley keeper supplied with the snow thrower, reusing the original bolt, washer and nut. NOTE: Some tractors may already be equipped with a pulley keeper that is identical to the new one supplied. Attach the clutch/idler assembly to the tractor frame as follows. Hook the assembly's notched arms onto the two shoulder bolts you assembled to the inside of the tractor frame. Lift the front of the assembly and attach it to the RH and L.H hanger brackets using two pivot lock pins (MM) and 1/8" hairpin cotters (KK) NEW ENGINE PULLEY KEEPER WITH ORIGINAL BOLT, NUT AND WASHER PIVOT LOCK PIN (MM) (use second hole) \ 1/8" HAIRPIN COTTER STEP 40: (SEE FIGURE 40) Assemble the short "V" belt onto the engine pulley and then onto the large pulley on top of the c_utch/idler assembly.The belt must be placed to the inside of the engine pulley keeper, the idler pulley and the keeper bolt located beside the large pulley IMPORTANT: Do Not assemb}e the "V" belt around the outside of the engine pulley keeper or timekeeper bolt. • Go to step 48 on page 21. CLUTCH/IDLER ENGINE PULLEY KEEPER ASSEMBLY Le# Side of Tractor PULLEY / \\ FIGURE 89 / N FIGURE 40 VIEWED FROM UNDERNEATH 18