Craftsman 24838 Operation Manual - Page 19

ELECTRIC ATTACHMENT CLUTCHES STEP 41: (SEE FtGURE 41) * Attach the two suspension arms to the inside of the clutch/idler assembly using two 5/16" x 3/4" hex bolts (E)> 5/16" washers (U) and 5/16" nylock nuts COO)for each arm. Place the washers between the arms and the assembly frame STEP 43: (SEE FIGURE 43) Hook the spring from the parts bag through the end of the tensioning chain Hook the other end of the spring onto the bottom of the bolt and nut which secure the idler pulley to the upper idler arm. Hold the bolt head and assemble a 3/8" hex lock nut (DD) onto the bolt, leaving enough space for the spring to pivot freely between the two nuts. Attach a 3/32" hairpin cotter (LL) to the chain, placing it in the fifth link from the spring• ATTACH SPRING HERE SPRING 5TH LINK CHAIN (LH. SIDE) 5/16" NYLOCK NUT (CC) 5/16" WASHER (U) 5/16" x 314" HEX BOLT (E) FIGURE 41 STEP 42: (SEE FIGURE 42) * Pace the extra tensioning chain (PP) through the left front hole in the cluteh4dler assembly and then turn the assembly upside down RIGHT SIDE FIGURE 43 3/32" HAIR COTTER PIN (LL) LEFT SIDE VIEW OF BOTTOM _- _ / LEFT FRONT HOLE FIGURE 42 TENSIONING CHAIN (PP) STEP 44: (SEE TABLE 2) Two different length drive belts are included with your snow thrower• Use the table below to select the correct drive belt for your type tractor The part number is printed on the outside of the belt Set aside the belt that is not for your tractor to avoid accidentally using it 55" CELT (PART #46989) TRACTOR TYPE DECK SiZE j_ CLUTCH TYPE (LT) Lawn Tractor 38", 42", 46" _ Electric 56" BELT (PART #48188) T(LRTA) CLTaOwnR TTraYcPtoEr TABLE 2 DEC4K8"SIZE _ CLUTECleHctriTcYPE 19