Cub Cadet ZTS1 50 Operation Manual - Page 12
Adjusting the Seat
View all Cub Cadet ZTS1 50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ASSEMBLY BATTERY MAINTENANCE • Some batteries are filled with battery acid and then sealed at the factory. However, even a "maintenance free" battery requires some maintenance to ensure its proper life cycle. • Spray the terminals and exposed wire with a battery terminal sealer or coat the terminals with a thin coat of grease or petroleum jelly, to protect against corrosion. • Always keep the battery cables and terminals clean and free of corrosion. • Some models are equipped with a battery containing a liquid electrolyte. Handle the battery with care and avoid tipping to prevent leakage. BATTERY STORAGE • When storing the tractor for extended periods, disconnect the negative battery cable. It is not necessary to remove the battery. • All batteries discharge during storage. Keep the exterior of the battery clean, especially the top. A dirty battery will discharge more rapidly. • The battery must be stored with a full charge. A discharged battery can freeze sooner than a charged battery. A fully charged battery will store longer in cold temperatures than hot. • Recharge the battery before returning to service. Although the tractor may start, the engine charging system may not fully recharge the battery. BATTERY REMOVAL WARNING Battery posts, terminals, and related accessories contain lead and lead compounds. Wash hands after handling. The battery is located beneath the seat frame. To remove the battery: 1. Remove the hex screw and square nut securing the black negative battery lead to the negative battery post (marked NEG (-)). Move the cable away from the negative battery post. 2. Remove the hex screw and square nut securing the red positive battery lead to the positive battery post (marked POS (+)). 3. Remove the battery hold down rod by pushing the hooked end out of the tab on the fender to the right side of the battery. Then flip the battery hold down rod up to free the battery. See Figure 13. 4. Carefully lift the battery out of the tractor. 5. Install the battery by repeating the above steps in the reverse order. CHARGING THE BATTERY Test and, if necessary, recharge the battery after the tractor has been stored for a period of time. Models with Lead-Acid Battery • A voltmeter or load tester reading of 12.4 volts (DC) or lower across the battery terminals indicates that the battery needs to be charged. • A lead-acid battery charger should be used. Recommended charge rate is 4A/14.7V. • If your battery charger is automatic, charge the battery until the charger indicates that charging is complete. If the charger is not automatic, charge for no fewer than eight (8) hours. Models with AGM Battery • An AGM battery charger should be used. Recommended charge rate is 1.1A/14.8V. IMPORTANT! Do NOT use an automotive charger. • If your battery charger is automatic, charge the battery until the charger indicates that charging is complete. If the charger is not automatic, charge for no fewer than eight (8) hours. Adjusting the Seat 1. Push and hold the seat adjustment lever to the left to adjust the seat position. 2. Slide seat forward or rearward to desired position. 3. Release the adjustment lever. Ensure seat is locked into position before operation. See Figure 14. Figure 14 (b) (a) Figure 13 12