D-Link 3350SR Reference Manual - Page 101

DES-3350SR Layer 3 Fast Ethernet Switch User's Guide Command show stp show stp ports Parameters Each command is listed, in detail, in the following sections. config stp ports Purpose Syntax Used to set up STP on the port level. config stp ports {cost [auto|]|priority |migrate [yes|no] | edge [true|false] |p2p [true|false|auto] |state [enabled|disabled]| Description This command is used to set up the Spanning Tree Protocol (STP) on the port level. Parameters − Specifies a range of ports to be configured. Ports are specified by entering the lowest port number in a group, and then the highest port number in a group, separated by a dash. So, a port group including the switch ports 1, 2, and 3 would be entered as 1-3. Ports that are not contained within a group are specified by entering their port number, separated by a comma. So, the port group 1-3 and port 49 would be entered as 1-3, 49. Additional ports can be individually entered by their port number, separated by commas. If you enter the ports sub-command, you can enter the port STP cost, priority, and state 101