Dell E2222H Users Guide - Page 44

Troubleshooting, Self-test, cable is disconnected or damaged.

Get Dell E2222H PDF manuals and user guides View all Dell E2222H manuals
Add to My Manuals
Save this manual to your list of manuals

Page 44 highlights

Troubleshooting WARNING: Before you begin any of the procedures in this section, follow the Safety instructions. Self-test Your monitor provides a self-test feature that allows you to check if your monitor is functioning properly. If your monitor and computer are properly connected but the monitor screen remains dark, run the monitor self-test by performing the following steps: 1. Turn off both your computer and the monitor. 2. Disconnect all video cables from the monitor. This way, the computer does not have to be involved. 3. Turn on the monitor. If the monitor is working correctly, it detects that there is no signal and one of the following message appears. While in self-test mode, the power LED remains white. Dell 22 Monitor ? No DP Cable The display will go into Standby mode in 4 minutes. www.dell.com/E2222H E2222H NOTE: This message also appears during normal operation, when the video cable is disconnected or damaged. 4. Turn off your monitor and reconnect the video cable; then turn on your computer and the monitor. If your monitor remains dark after you reconnect the cables, check your video controller and computer. 44 │ Troubleshooting

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
44
│
Troubleshooting
Troubleshooting
WARNING: Before you begin any of the procedures in this section, follow
the
Safety instructions
.
Self-test
Your monitor provides a self-test feature that allows you to check if your monitor is functioning
properly. If your monitor and computer are properly connected but the monitor screen remains
dark, run the monitor self-test by performing the following steps:
1.
Turn off both your computer and the monitor.
2.
Disconnect all video cables from the monitor. This way, the computer does not have to be
involved.
3.
Turn on the monitor.
If the monitor is working correctly, it detects that there is no signal and one of the following
message appears. While in self-test mode, the power LED remains white.
Dell 22 Monitor
No DP Cable
www.dell.com/E2222H
The display will go into Standby mode in 4 minutes.
E2222H
?
NOTE: This message also appears during normal operation, when the video
cable is disconnected or damaged.
4.
Turn off your monitor and reconnect the video cable; then turn on your computer and the
monitor.
If your monitor remains dark after you reconnect the cables, check your video controller
and computer.