Dell Force10 S50P FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 1088
permit, no seq, range, If you know the filter sequence number, use
View all Dell Force10 S50P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1088 highlights
www.dell.com | support.dell.com permit c e s Configure a rule for the redirect list. Syntax permit {ip-protocol-number | protocol-type} {source mask | any | host ip-address} {destination mask | any | host ip-address} [bit] [operators] To remove the rule, use one of the following: • If you know the filter sequence number, use the no seq sequence-number syntax. • no permit {ip-protocol-number | protocol-type} {source mask | any | host ip-address} {destination mask | any | host ip-address} [bit] [operators] Parameters ip-protocol-number protocol-type source mask any host ip-address destination bit operator Enter a number from 0 to 255 for the protocol identified in the IP protocol header. Enter one of the following keywords as the protocol type: • icmp for Internet Control Message Protocol • ip for Any Internet Protocol • tcp for Transmission Control Protocol • udp for User Datagram Protocol Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all traffic is subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) For TCP protocol type only, enter one or a combination of the following TCP flags: • ack = acknowledgement • fin = finish (no more data from the user) • psh = push function • rst = reset the connection • syn = synchronize sequence number • urg = urgent field (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port command parameter.) Defaults No default behavior or values Command Modes REDIRECT-LIST Command History Version 8.4.2.1 Version 8.4.2.0 Version 7.5.1.0 Introduced on the C-Series and S-Series Introduced on the E-Series TeraScale Introduced on the E-Series ExaScale 1088 | Policy-based Routing (PBR)