Dell Force10 S50P FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 621
show config, show interfaces port-channel
View all Dell Force10 S50P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 621 highlights
Usage Information This feature groups two LAGs to work in tandem as a supergroup, so that, for example, if one LAG goes down, the other LAG is taken down automatically, providing an alternate path to reroute traffic, avoiding oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to configure failover groups. For details, see the Port Channel chapter in the FTOS Configuration Guide. Related Commands group show interfaces port-channel Group two LAGs in a supergroup ("fate-sharing group"). Display information on configured Port Channel groups. show config c e s Display the current configuration of the selected LAG. Syntax show config Command Modes INTERFACE PORTCHANNEL Example Figure 23-44. show config Command Sample Output for a Selected LAG FTOS(conf-if-po-1)#show config ! interface Port-channel 1 no ip address shutdown FTOS(conf-if-po-1)# Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series show interfaces port-channel c e s Display information on configured Port Channel groups. Syntax show interfaces port-channel [channel-number] [brief] Parameters channel-number brief For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. (OPTIONAL) Enter the keyword brief to display only the port channel number, the state of the port channel, and the number of interfaces in the port channel. Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Version 7.6.1.0 Introduced on E-Series ExaScale Introduced for S-Series; Modified to display LAG failover group status Interfaces | 621