Dell Force10 S50P FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 1508
show hardware interface Command Example, Table 64-2.
View all Dell Force10 S50P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1508 highlights
www.dell.com | support.dell.com Example Figure 64-10. show hardware interface Command Example FTOS#show hardware interface gig 1/0 phy MII Control Register SpeedSelection: 1000Mbps AutoNeg: ON Loopback: False PowerDown: Flase Isolate: Flase DuplexMode: Full MII Status Register : AutoNegComplete: False RemoteFault: False LinkStatus: False JabberDetect: False PHY Identifier Register : PHY Identifier Register : Auto-Negotiation Advertisement Register 100MegFullDplx: True 100MegHalfDplx: True 10MegFullDplx: True 10MegHalfDplx: True Asym Pause: False Sym Pause: True Auto-Negotiation Link Partenr Register : 100MegFullDplx: False 100MegHalfDplx: False 10MegFullDplx: False 10MegHalfDplx: False Asym Pause: False Sym Pause: False 1000Base-T Control Register: Master/Slave Mode: Auto 1000MegFullDplx: True 1000MegHalfDplx: True 1000Base-T Status Register Master/Slave Fault: No Master/Slave: Slave Local RX OK: False Remote RX OK: False Link Partner 1000MegFullDplx: False Link Partner 1000MegHalfDplx: False Idle Error Count: 0 1000Base-T/100Base-TX/10Base-T IEEE Extnd Status Register 1000Base-T/100Base-TX/10Base-T PHY Extnd Control Register Automatic MDI Crossover Mode: Enable 1000Base-T/100Base-TX/10Base-T PHY Extnd Status Register Automatic MDI Crossover State: Crossover Table 64-2. show hardware rpm number mac Output Description Mode Control Mode Status AutoNegotiation Advertise AutoNegotiation Remote Partner's Ability AutoNegotiation Expansion Indicates whether auto-negotiation is enabled and the selected speed and duplex. Displays auto-negotiation fault information. The AutoNegComplete shows True and the LinkStatus field says OK when the interface completes auto-negotiation successfully. Displays the control words advertised by the local interface during negotiation. The duplex can be full-duplex or half-duplex. The "AsymPause" and "SymPause" describes the types of flow control supported by the local interface. Displays the control words advertised by the remote interface during negotiation. The duplex can be full-duplex or half-duplex. The "AsymPause" and "SymPause" fields describe the types of flow control supported by the remote interface. Parallel detection refers to a handshaking scheme in which the link partners continuously transmit an "idle" data packet using the Fast Ethernet MLT-3 waveform. Equipment that does not support auto-negotiation must be configured to exactly match the mode of operation as the link partner, or else no link can be established. 1508 | C-Series Diagnostics and Debugging