Dell Force10 S50P FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 241
permit udp
View all Dell Force10 S50P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 241 highlights
permit udp c e s Configure a filter to pass UDP packets meeting the filter criteria. Syntax permit udp {source mask | any | host ip-address} [operator port [port]] {destination mask | any | host ip-address} [dscp] [operator port [port]] [count [byte] | log] [order] [monitor] [fragments] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit udp {source mask | any | host ip-address} {destination mask | any | host ip-address} command. Parameters source mask any host ip-address dscp operator port port destination count byte log order monitor fragments Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. Enter this keyword to deny a packet based on DSCP value. Range: 0-63 (OPTIONAL) Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port parameter.) (OPTIONAL) Enter the application layer port number. Enter two port numbers if using the range logical operand. Range: 0 to 65535 Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. Range: 0-254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority) Default: If the order keyword is not used, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule will be applied to the monitored interface. For details, see the section "Flow-based Monitoring" in the Port Monitoring chapter of the FTOS Configuration Guide. Enter the keyword fragments to use ACLs to control packet fragments. Defaults Not configured. Access Control Lists (ACL) | 241