Dell GX260 Service Manual - Page 36

Installing a Hard Drive, Removing the Hard Drive, Drive Bracket Rails

Get Dell GX260 - Optiplex Pentium 4 2.0GHz 512MB 40GB CD PDF manuals and user guides
UPC - 683728163389
View all Dell GX260 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

2 hard-drive cable 2. Press in on the tabs on each side of the drive, slide the drive toward the I/O panel, and remove it from the computer. Removing the Hard Drive Installing a Hard Drive 1. Unpack the replacement hard drive, and prepare it for installation. 2. If your replacement drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive. Attach the bracket rails to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails, and then inserting and tightening all four screws (two screws on each rail). Drive Bracket Rails 1 drive 2 bracket rails (2) 3 screws (4)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
2
hard-drive cable
2. Press in on the tabs on each side of the drive, slide the drive toward the I/O panel, and remove it from the computer.
Removing the Hard Drive
Installing a Hard Drive
1. Unpack the replacement hard drive, and prepare it for installation.
2. If your replacement drive does not have the bracket rails attached, remove the rails from the old drive by removing
the two screws that secure each rail to the drive. Attach the bracket rails to the new drive by aligning the screw holes
on the drive with the screw holes on the bracket rails, and then inserting and tightening all four screws (two screws on
each rail).
Drive Bracket Rails
1
drive
2
bracket rails (2)
3
screws (4)