Dell Latitude XT User's Guide - Page 195
Installing the Pen and Whip Antenna Assembly, Wireless Switch, Removing the Wireless Switch
View all Dell Latitude XT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 195 highlights
1 pen and whip antenna assembly 2 3 M2 x 3-mm screws (2) 4 5 base pen-missing cable whip antenna cable Installing the Pen and Whip Antenna Assembly 1 Seat the pen-missing cable and whip antenna cable into their routing channels. Route the pen-missing cable through the base hooks by the grip area. Use tape to hold the cable down through the base hooks. 2 Tighten the two M2 x 3-mm screws. 3 Install the system board (see "Installing the System Board" on page 191). 4 Install the palm rest (see "Installing the Palm Rest" on page 189). 5 Install the display assembly (see "Installing the Display Assembly" on page 182). 6 Install any Mini-Cards (see "Installing a Mini-Card" on page 173). 7 Install the keyboard (see "Installing the Keyboard" on page 177). 8 Install the hinge cover (see "Installing the Hinge Cover" on page 175). Wireless Switch CAUTION: Before performing the following procedures, follow the safety instructions in your Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the Tablet-PC. NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the Tablet-PC. Removing the Wireless Switch 1 Follow the procedures in "Before You Begin" on page 155. 2 Remove the hinge cover (see "Removing the Hinge Cover" on page 174). 3 Remove the display assembly (see "Removing the Display Assembly" on page 179). Adding and Replacing Parts 195