Dell OptiPlex 3000 Micro Micro Service Manual - Page 19
Hard-drive assembly, Removing the hard-drive assembly
View all Dell OptiPlex 3000 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Steps 1. Align the notch on the solid-state drive with the tab on the solid-state drive connector on the system board. 2. Insert the solid-state drive at a 45-degree angle into the solid-state drive connector. 3. Replace the screw (M2x3.5) that secures the M.2 2280 PCIe solid-state drive to the system board. Next steps 1. Install the hard-drive assembly. 2. Install the side cover. 3. Follow the procedure in after working inside your computer. Hard-drive assembly NOTE: This section applies to 35 W and 65 W configuration systems. Removing the hard-drive assembly Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. About this task The following images indicate the location of the hard-drive assembly and provide a visual representation of the removal procedure. Removing and installing components 19