Dell OptiPlex 3000 Micro Micro Service Manual - Page 37
About this task, Steps, Next steps, serial module to the computer chassis.
View all Dell OptiPlex 3000 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
About this task The following images indicate the location of the system board and provide a visual representation of the installation procedure. Steps 1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket. Push the bracket to release the bracket, and then lift the bracket out from the system. 2. Insert the optional I/O module into its slot from the inside of your computer. 3. Connect the I/O cable to the connector on the system board. 4. Replace the two (M3x3) screws that secure the optional I/O modules or two (M2x5) cross type screws that secure the serial module to the computer chassis. Next steps 1. Install the side cover. 2. Follow the procedure in after working inside your computer. Removing and installing components 37