Dell OptiPlex 3000 Micro Micro Service Manual - Page 9
Removing and installing components, Recommended tools, Screw list, Major components of OptiPlex 3000
View all Dell OptiPlex 3000 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
2 Removing and installing components NOTE: The images in this document may differ from your computer depending on the configuration you ordered. Recommended tools The procedures in this document may require the following tools: ● Phillips screwdriver #0 ● Phillips screwdriver #1 ● Torx #5 (T5) screwdriver ● Plastic scribe Screw list NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced. NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component. NOTE: Screw color may vary with the configuration ordered. Table 1. Screw list Component Side cover Screw type #6-32 (Captive screws) Quantity 1 Image System board Heat sink WLAN card M3x5 5 M3x4L 3 M3x25 (Captive screws) 3 M2x3.5 1 M.2 2230/2280 Solid-state drive Internal Antenna M2x3.5 2 M3x3MM 3 Major components of OptiPlex 3000 Micro The following image shows the major components of OptiPlex 3000 Micro. Removing and installing components 9