Dell OptiPlex 3000 Micro Micro Service Manual - Page 36
Installing optional I/O modules (HDMI/VGA/DP/Serial), Steps, Prerequisites
View all Dell OptiPlex 3000 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Steps 1. Remove the two (M3x3) screws that secure the optional I/O modules or two (M2x5) cross type screws that secure the serial module to the computer chassis. 2. Disconnect the I/O-module cable from the connector on the system board. 3. Remove the I/O module from the computer. Installing optional I/O modules (HDMI/VGA/DP/Serial) Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. 36 Removing and installing components
Steps
1.
Remove the two (M3x3) screws that secure the optional I/O modules or two (M2x5) cross type screws that secure the
serial module to the computer chassis.
2.
Disconnect the I/O-module cable from the connector on the system board.
3.
Remove the I/O module from the computer.
Installing optional I/O modules (HDMI/VGA/DP/Serial)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
36
Removing and installing components