Dell PowerConnect W Clearpass 100 Software Cisco WLC Integration Guide - Page 25
Testing the Configuration
View all Dell PowerConnect W Clearpass 100 Software manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Testing the Configuration Now that the configuration of both the Cisco WLC and the Amigopod solution is complete, the following steps can be followed to verify the setup. Step 1 - Connect to the Amigopod wireless network Use a test laptop to attempt to connect to the advertised amigopod_guest wireless network. The screen capture below shows the interface used on a Windows 7 based laptop. Although the process differs from laptop to laptop depending on the wireless card drivers installed and different operating systems in use, the basic premise of connecting to the Guest Wireless network should be fundamentally the same. Refer to your laptop manufacturer's documentation on the procedure for connecting to wireless networks if you experience an issue connecting to the guest network.. Note: If the amigopod_guest wireless network is not visible from the test laptop, double check the configuration of the Cisco WLC and potentially source a second wireless test device to see if the problem is laptop specific. CONFIDENTIAL 25