Dell PowerConnect W-Series FIPS Dell PowerConnect W-600 Controller Series Secu - Page 11

Table 2 Media Eject Button LED Behavior Initial State LED State Action Status LED NAS Media Operational Green-solid Press and hold media eject button for 1 to 5 seconds only Amber-flashing NAS Media Unmounted Amber-solid Press and hold media eject button for 1 to 5 seconds only Amber-flashing Operational Operating with NAS Media un-mounted Standby Green-solid Press and hold media eject button for more than 5 seconds only Red-flashing Amber-solid Press and hold media eject button for more than 5 seconds only Red-flashing Red-solid Press media eject button Amber-flashing Function LED Action Completed Un-mount all NAS Amber-solid media Mount all attached NAS devices, and return to fully functional operation Green-solid Controller goes into Standby Red-solid Controller goes into Standby Red-solid Controller wake-up Green-solid In non-rack deployments, the Aruba 620 is placed with the front facing out. This allows the cables to be hidden and creates a more aesthetically pleasing look. Therefore, a set of LEDs displaying link activity on the ports is placed on the front side. Same LEDs also exist in back side too. For information about the behavior of these LEDs, see table below. Table 3 Aruba 620 LED Status Indicators LED Label Function Indicator Status Power Status POWER STATUS 10/100/1000Base-T Port LNK/ACT 1000 Input Power Status Indicator Module Status Indicator Link/Activity Status Indicator Interface Speed On (Solid Green) Off On (Solid Green) On (Solid Red) On (Solid Amber) Off On (Solid Green) On (Flashing Green) Off On (Solid Green) Off Power on No Power Device is operational Device failed or is in Standby Device is loading software No power Link has been established Port is transmitting or receiving data No link on port 1000 Mbps 10/100 Mbps Aruba 620, 650 and Dell W-620, W-650 | FIPS 140-2 Level 2 Release Supplement The Aruba 620 and 650 Mobility Controllers | 11