Dell PowerConnect W-Series FIPS Dell PowerConnect W-600 Controller Series Secu - Page 38

Applying TELs,

Page 38 highlights

Figure 12 Aruba 650 - Top view Figure 13 Aruba 650 - Bottom view Applying TELs The Crypto Officer is responsible for securing and having control at all times of any unused tamper evident labels. The Crypto Officer should employ TELs as follows:  Before applying a TEL, make sure the target surfaces are clean and dry.  Do not cut, trim, punch, or otherwise alter the TEL.  Apply the wholly intact TEL firmly and completely to the target surfaces.  Ensure that TEL placement is not defeated by simultaneous removal of multiple modules.  Allow 24 hours for the TEL adhesive seal to completely cure.  Record the position and serial number of each applied TEL in a security log. Once the TELs are applied, the Crypto Officer (CO) should perform initial setup and configuration as described in the next chapter. 36 | Installing the Controller Aruba 620, 650 and Dell W-620, W-650 | FIPS 140-2 Level 2 Release Supplement

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42

36
|
Installing the Controller
Aruba 620, 650 and Dell W-620, W-650
|
FIPS 140-2 Level 2 Release Supplement
Figure 12
Aruba 650 — Top view
Figure 13
Aruba 650 — Bottom view
Applying TELs
The Crypto Officer is responsible for securing and having control at all times of any unused tamper evident
labels. The Crypto Officer should employ TELs as follows:
Before applying a TEL, make sure the target surfaces are clean and dry.
Do not cut, trim, punch, or otherwise alter the TEL.
Apply the wholly intact TEL firmly and completely to the target surfaces.
Ensure that TEL placement is not defeated by simultaneous removal of multiple modules.
Allow 24 hours for the TEL adhesive seal to completely cure.
Record the position and serial number of each applied TEL in a security log.
Once the TELs are applied, the Crypto Officer (CO) should perform initial setup and configuration as
described in the next chapter.