Dell PowerEdge M420 Dell PowerEdge M420 Systems Owner's Manual - Page 41
Installing The Blade System Board, Remove the SSDs.
View all Dell PowerEdge M420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
WARNING: The memory modules are hot to the touch for some time after the system has been powered down. Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components. 2. Remove the SD card and the vFlash card. 3. Remove the mezzanine card/blank. 4. Remove the SSDs. NOTE: If you are removing both SSDs, label them so you can replace them in their original locations. 5. Remove the SSD backplane. CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components. 6. Hold the blade chassis with one hand, lift and pull the blade release handle with the other hand to slide the blade system board out of the open end of the chassis. 7. Remove the memory modules and memory module blanks. 8. Remove the processor(s). Figure 17. Removing and Installing the Blade System Board 1. blade release handle 2. blade system board 3. blade chassis Installing The Blade System Board 1. Transfer the following components to the new blade system board: a) Memory modules and memory module blanks. b) Processor(s) and heat sink(s), or processor/DIMM blank. 41